I want to change the front sight on my DPMS. I got a gas block from them to put on.
The pins on the factory one, look like they are pined over on the ends. Do you have
to file off one end, to nock them out?
AR Front Sight
-
- Serious Gun Trader
- Posts: 335
- Joined: Sat Apr 27, 2013 11:11 am
- City: Spokane
- State: WA
- Favorite Firearm: 1911
- Next Firearm: BFR
AR Front Sight
Guns are a lot like parachutes. If you need one and don't have one, you'll probably never need one again.
-
- Senior Accomplished Gun Trader
- Posts: 1430
- Joined: Tue May 24, 2011 8:10 pm
- City: Bozeman
- Favorite Firearm: G21
- Next Firearm: Savage 110FCP-K
- Location: Bozeman
Re: AR Front Sight
They should be taper pins. Tap the skinnier end and they should back right out.
-
- Serious Gun Trader
- Posts: 335
- Joined: Sat Apr 27, 2013 11:11 am
- City: Spokane
- State: WA
- Favorite Firearm: 1911
- Next Firearm: BFR
Re: AR Front Sight
Thank You
Guns are a lot like parachutes. If you need one and don't have one, you'll probably never need one again.